marijuana stocks for sale

How to Make Rick Simpson Oil

Rick Simpson Oil (which we’ll be shortening to “RSO” through-out our article) is a marijuana extract often touted as a miraculous cure. It’s eponymous creator, seeking treatment for his skin cancer, turned to this cannabis oil as a remedy – His subsequent recovery has become the stuff of legend, and its creator, now a legendary cannabis activist in his own right, has done much to ensure his recipe can be spread as widely – and freely – as possible. marijuana stocks for sale | how-to-make-rick-simpson-oil

Today we’ll be talking about RSO – What this famous oil is, how to make it at home, and even tackle the big question of if Rick Simpson Oil really does cure cancer. We’ve got a lot to go over, so let’s get started.

What is Rick Simpson Oil?​

A cannabis concentrate, RSO is a highly-concentrated, full-spectrum THC oil (often applied as a tincture) made from Indica-dominant strains of cannabis plant. If you’ve read any of our other articles on HighThere! about making cannabis concentrates such as canna coconut oil or kief butter, you’ll know we stress small but important steps, such as decarboxylation and proper steeping methods; Rick Simpson Oil is, in it’s creation, a master culmination of all these techniques. marijuana stocks for sale | how-to-make-rick-simpson-oil

What we’re going to outline below is the official, as stated by Rick Simpson, way to make RSO. We’ll also be adding in some of our own notes and recommendations as we go along – The official recipe as written was designed to be effective but accessible to those without much in the way of kitchen equipment, and we want to both respect that and offer smart alternatives for those who may have such access. Let’s get started.

Note: All instructions contained in this article are here for educational and informational purposes only. This recipe includes flammable liquids that can cause deadly fires or even explosions if not handled properly. Lives have been lost attempting amateur cannabis extractions. Do not try this at home.

Rick Simpson Oil Recipe

This recipe creates 60 grams (or 60 milliliters) of RSO. You’ll need the following:

  • 450/500 grams of cannabis bud. Raw, high-quality is preferred, with the original recipe calling for either a pure indica strain or an indica-dominant variety (IE: no more than 10% sativa strain). Decarbed weed can be used; see our notes below.
  • 8 to 9 liters of solvent. As RSO is designed to be medicinal, a 99% isopropyl alcohol solution is recommended. Other solvents can be used, but both Rick Simpson and us stick by 99% iso alcohol for RSO.
  • A length of wood. This is to stir your cannabis/solvent solution – A wooden spoon will work but we recommend using something food-safe and non-porous (metallic, silicone, ceramic, etc.) if available.
  • Two 20 liter buckets. Use whatever is available but if you have access to stainless steel this would be preferred.
  • Small containers; for holding the initial solvent mixture – We recommend something glass, such as Mason jars.
  • Funnels
  • Coffee filters
  • An electric rice cooker; other slow cooking or double-boiling techniques will work but will require more active watching and can pose a greater fire hazard.
  • A large fan
  • Measuring cups; Rick recommends stainless steel but any suitable measuring cup in your kitchen should work just as well.
  • An oven; other forms of slow-heating methods can be used here – Rick also recommends a coffee warmer.
  • Clear syringes, needles removed & cap available. A catheter tip syringe will work well for this purpose.

Before you Begin:

Your cannabis bud should be thoroughly dried and somewhat crunchy to the touch; though decarbing isn’t requested in the original RSO recipe (as the concentrate is decarbed later in the process) decarbed weed would work just fine here and be well-dried. We also recommend grinding your buds prior to soaking; this increases surface area of your plant material, allowing for an easier and more thorough soak, as well as giving you the opportunity to remove any stems or seeds that may be present.

If at all possible, make as much – preferably all – of this recipe outdoors. If any portions of this recipe must be indoors proper ventilation is a must – As a large part of this process relies on the evaporation of alcohol, fumes CAN and WILL easily ignite. All windows in the area should be open, and if available other fans should be set up pointed to face the outside.

Making the RSO:

Place your cannabis bud into your first container, followed by your solvent – Adding in your bud first will help prevent the solvent from sloshing out as if done the other way around. If you did not pre-grind your bud, add only a bit of solvent to help dampen the weed, then crush it with your stirrer of choice. Then, add more solvent slowly until your plant material is completely covered and “loose” in the alcohol.

Using your stirring implement (wooden spoon or otherwise) now begin to crush and stir your marijuana. Think of this motion as muddling a drink (a rather true metaphor given the alcohol involved) – You’re attempting to infuse the alcohol-based solvents with the THC-bearing oils inside the marijuana by breaking it further apart, and stirring it into the liquid. Work this mixture back and forth for a minimum of three to four minutes.

Once done, carefully pour the infused solvent/oil liquid into your second large container (IE: bucket), leaving as much of your original material behind in the first bucket as possible. The more loose your plant matter the more difficult this will be, so consider using a cheesecloth-lined strainer when transferring from the first container to the second.

The Second Wash:

Now repeat the above process with the same cannabis, essentially giving it a second rinse with your solvent. This second wash is less potent overall than the first wash but is still quite effective, and when combined with the first wash gives your Rick Simpson Oil a fairly complete spectrum of the cannabinoids present in the plant material.

Working carefully, pour the alcohol/oil solvent mixtures into your smaller (preferably glass) containers, which should be topped with coffee-filter lined funnels. This solvent will slowly drip down through the coffee filters into the vessels below, further straining out any potential impurities or plant material left in the solution. This may take some time, and the process will go faster the more filters/containers you use. Once the mixture has been completely strained through, an additional quick rinse with solvent can clear off any remaining THC oil left on the coffee filters.

Heating Begins:

Pour your strained solution directly into your rice cooker – A rice cooker is recommended due to it’s auto-temperature control settings, preventing your oil from overheating. Fill until at roughly the three-quarters mark; not over-filling will lessen the risk of hazardous splashes.

Turn your rice cooker on and let the solution begin to heat up – As it heats, the alcohol solvent will turn into fumes and evaporate, leaving behind a virtually pure cannabis oil concentrate. While your solution is heating make sure your fan is on and close to the cooker, blowing over it’s top – This will both help speed up the evaporation process and help dissipate the harmful alcohol fumes. Again, this should be done outside if at all possible, or with open windows and ventilation at a bare minimum; these fumes can and will easily ignite.

Finishing Your RSO:

The rice cooker will automatically switch off before bringing the RSO up to a temperature that will cause it to burn, meaning you can let this sit for as long as you like, though two cycles of power (IE: high to low to high again) is recommended. Given the temperatures involved (bringing your concentrate up to roughly 220 F this has the side benefit of decarboxylating the THC concentrate as well (hence the lack of need for decarbed weed).

After this, the recipe recommends using either a coffee warmer or an oven to heat the oil to roughly 250 F for 30 minutes to an hour, for additional decarboxylation and to help remove any remaining water & solvent. Once this final step is complete, your RSO is ready to store.

Storing Rick Simpson Oil:

Though this oil can be stored in any number of ways the traditional method is via syringe, to accommodate for easier dosing. Any clear syringe will work, so long as the needle has been removed and a cap is available for the tip. Place the end of the syringe into the oil and, drawing back gently on the plunger, fill with material to the desired amount. Repeat as needed.

And there you have it. RSO is, in a lot of ways, similar to many other cannabis concentrates, though very precise in it’s technique and methodology.

What Can Rick Simpson Oil Be Used For?

First and foremost, this is a very stout, high-THC-content cannabis concentrate, so above and beyond anything else it will get you high – Smoked, eaten, vaped, RSO is about as pure a true “weed concentrate” as it gets. But beyond the most dedicated of pot heads most people don’t turn to RSO to get blazed; most seek this oil out for it’s potential medical benefits.

What is RSO good for? Well, what else is cannabis supposed to help with? Without trying to sound glib or casting any shade on the legacy or effectiveness of RSO, right now it’s difficult to say with any true scientific validity exactly what cannabis does help with. What we do know is that cannabis has shown promising results in clinical trials for treating a wide array of ailments, ranging from seizures to migraines to cancer. Which conveniently leads us into…

Does Rick Simpson Oil Cure Cancer?

As mentioned in the intro, Rick Simpson was diagnosed with skin cancer (basal cell carcinoma). No stranger to using cannabis for medical ailments, and an engineer by trade, Simpson used his knowledge of cannabis to create the highest grade medicinal product he knew how, applying it as a tincture to the area of his cancer. According to his claims within four days all cancer cells & related growths disappeared, and has has been without cancer since. marijuana stocks for sale | how-to-make-rick-simpson-oil

He is not alone. There are hundreds of similar claims, all saying that usage of RSO has helped with not only their skin cancer but from other forms of cancer patients and many ailments beyond that as well. But there’s a reason we use the word “claims”.

Again, there is promising scientific evidence for using cannabis as a treatment for a wide variety of issues (cancer and beyond), including the original studies done by the National Cancer Institute that inspired Rick Simpson’s oil-making technique, there is no current, prevailing proof that cannabis treatments such as RSO are effective (and, of course, we here at High There are not doctors or medical professionals of any sort – no information in this article [or on our website] is to be construed as medical advice).

but. While there is importance in being honest about the validity of information, saying that science “doesn’t know” means exactly that – RSO’s effectiveness is unknown, meaning neither medically proven nor disproven. And while there may still be needed scientific research to be done before cannabis can be quantified as legitimate medical treatment, that doesn’t mean that colloquial evidence should be completely ignored in the meantime. If someone who is suffering believes cannabis can help ease that suffering in any fashion, seeking whatever relief and remedy they feasibly can is only natural.

All of this said, as with any sort of medicine, speak to your medical professional before adding any kind of supplement to your existing treatment plan, and make sure medical marijuana is right for you and your healing process. marijuana stocks for sale | how-to-make-rick-simpson-oil

Can I Make CBD Rick Simpson Oil?

You absolutely can – In fact Rick Simpson himself discusses this as a viable alternative for those seeking cannabis remedies without the highs of THC. Though the original recipe for RSO calls for buds from Indica-dominant strains any strain of cannabis can be substituted to excellent results in the end concentration; CBD-heavy hemp strains are no different.

To make CBD RSO just replace the cannabis in the above solution with CBD-rich hemp strains. That’s it, nothing else to it. RSO is, essentially, a high-grade cannabis concentrate, so like we said above, any strain you care to use will ultimately work to make a CBD oil at Rick Simpson standards. marijuana stocks for sale | how-to-make-rick-simpson-oil

Wrapping Up

We hope our article on how to make Rick Simpson Oil has helped you learn more about this useful THC concentrate. Many medical marijuana patients have looked to the simple, easy-to-follow instructions of Rick Simpson to make this oil and we hope we’ve done him justice in our write-up.

Have you ever tried Rick Simpson Oil? Or know of any interesting variations on his technique? We’d love to know! Until next time take care, and happy smoking! marijuana stocks for sale | how-to-make-rick-simpson-oil


  1. Charles Dawings August 23, 2021 at 1:30 pm - Reply

    These guys are great. Really nice and great communication. Good options for any price level / they work with you to get what you need. Vapes are the only ones I use around the market rn and haven’t had any issues. Good flavor selections and they switch up the menu a lot. ONLY reason I’m leaving them is because I’m moving out the area. So sad to leave you guys but thank you for being awesome!

  2. Girl scout crack October 22, 2021 at 5:18 pm - Reply

    Thank you for the good writeup. It in fact was a amusement account it.
    Look advanced to far added agreeable from you! However,
    how can we communicate?

  3. Chong January 22, 2022 at 3:00 pm - Reply

    You’re a really helpful site; couldn’t make it without ya!

Leave a Comment

Your email address will not be published.